Remote Control Ceiling Fan Light Wont Turn Off

The first step is to see if the remote was faulty.

Remote control ceiling fan light wont turn off.

Turn on the power from the mains. Make sure the blue wire from the receiver is wired to the blue or black with white stripe if a hunter from the fan. Wait for 30 seconds before turning the fan on again. If you want to reset the remote.

If the above does not resolve the issue continue to the following steps to check for over heating. One of the wires from the ceiling should be capped off usually the red one. However the light on the fan works and the remote does control the light. Turn off the ceiling fan using the remote.

The process will change the frequency settings and allow the remote to work again. The remote module has a set of small dip switches on the side of the module. For 10 seconds hold down the off button. Run the ceiling fan for a few minutes.

Turn of your fan using its dedicated remote control. It is controlled by a remote control only no switch. The fan is on and won t turn off. I hope this helps.

If the lights are still stuck on at this point it is time to replace the receiver. Generally you ll need to open the housing to find it. Resetting your remote setting is easy and it only takes a few easy steps. Typically there is also a wall switch.

I tried replacing the battery for the remote already and i tried turning off the power to the house. Turn off the ceiling fan and allow the blades to come to a full stop. Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow.

Open the battery cover of your remote control under the battery will be a set of dip switches match the dip switch code from your old remote to the new remote test to see if the lights can be turned off. Reset the fan remote. If the fan sometimes turns on by itself off by itself or the light kit does this on it s own then this is a good sign you do need to change the dipswitches. Hunter fan remote reset follows the same steps making the troubleshooting easy.

Clean and lubricate the ball bearings. Replace the ceiling fan capacitor. Once complete return the battery and cover the remote. My ceiling fan will not turn off.

You will also find a corresponding set of dipswitches on the fan. To determine the cause of the fan speed malfunction follow the steps below. You can use that to turn the fan on and off. The bad news is the fan canopy must be dropped to access the receiver.

Reset the remote of your fan. When i turn the power back on the fan goes back on. Dipswitches are toggle switches on the back of the remote. Change the switch setting to match the settings of the hand held remote control.