Removing Piece Of Siding From House

Use a small hacksaw with a sharp blade.

Removing piece of siding from house.

If it remains stuck double check to see if. Pull the piece of vinyl siding downward to disengage it from the course below it. Cut the nails at the bottom of the row above the boards you re replacing. Cutting the nails will let you remove rotted boards without damaging those your e saving.

Lift up the very top portion of the trim to expose the top edge of the vertical siding. More importantly removing one piece of siding should expose the nails on another piece that would normally be covered. Slide the hook of the zip tool between the buttlock lip and toplock. Insert the tip of the zip tool into the notch.

Go to the end of that row either near a corner. Usually the nails will be below the piece of siding you removed. Once all the nails are removed from the adjoining board the damaged one should just pull out. Look for a horizontal seam between two courses of vinyl siding.

Pull the zip tool out to disengage the. Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1. Locate the vinyl siding piece above the piece you need to replace. Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.

How to remove small pieces of vinyl siding 1. Look under the siding piece you just located for a short flat notch. Working in one direction unzip. However depending on how your siding is arranged they could be to the left or the right as well.

Pull out the. Score down the damaged lap siding with a utility knife. If the siding is hard to remove try tapping it with the palm of your hand. Insert the siding removal tool where the panels overlap and pull down and out.

Remove the nails in the corner cap.