Repairing Glazing Old Windows

This exposes the metal glazier s points.

Repairing glazing old windows.

If the old glass is in good shape leave it in place. Strip the old glazing and paint as required to remove the old glazing points small pieces of metal placed every six inches or so in the frame to hold the glass firmly to the sash. With the glass thoroughly broken up pull the shards out of the frame by hand. If the glazing is still in place and looks good for part of the window it can stay but it s best to completely remove any glazing that looks chipped or loose because it can prevent the new glazing from adhering as it should.

Once the old glazing is removed as well as the glass scrape the mullions with the triangular scraper to remove any glazing or old paint. The sharp tip of a paint scraper can be used to carefully remove the points without damaging the glass. Pry them out of the wood. This step may not be needed if all wood surfaces are perfectly sound.

Sarco glazing putty this is the only brand of glazing putty i recommend. If your windows will be glazed outside and exposed to the elements prior to painting use sarco dual glaze. Average time to do the above work is one hour per six pane window. If the bottom edge of the lower sash s.

A primer is not needed. It is linseed oil based and as close to the old stuff they used to use. Sand wood surfaces if needed. Paint the exposed wood with either a primer or use an epoxy consolidant.

Scrape the putty away with a putty knife. Sand primed surfaces if needed. It is important that in painting the glazing the paint flows onto a small part of the glass to make a weather tight seal. The epoxy will soak into the wood and make it harder than original as well as waterproof.

Soften old hardened putty glazing compound with a heat gun set to medium and fitted with a nozzle shield. The glass should be cleaned so that all of the putty oils are removed. Repair a wood window in 12 steps. Put on heavy gloves and eye protection place a cloth over the broken pane and tap it with a hammer.

If you are glazing your windows in a garage or shop use sarco type m putty. The points are covered by glazing compound. Remove the glass and label it so you know which opening to put it back into. If you used the epoxy consolidant to coat your window sand it to remove the gloss and then paint with a good acrylic.