Repairvinyl Siding Bottom

Hold the removed segment up to a spare piece of vinyl siding.

Repairvinyl siding bottom.

Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Repeat the procedure for the top of the damaged siding. You may want to wait for a warm day when the siding will be softer and more pliable. Start at the bottom of the piece that is being replaced and insert a wooden shim between the pieces of siding as the zip tool slides along the siding.

Cut the spare piece of vinyl along the marks using straight tin snips. The damaged panel of vinyl siding will now be flapping free since you have disconnected it at the top and bottom. Use zip tool to. Cut a vinyl patch 4 inches 10 cm wider than the removed segment.

To replicate the. Pull siding away from house and cut through the bottom edge with aviation snips. Cut piece of faded siding from an inconspicuous spot to replace the damaged section. Remove the nails holding the strip directly above the damaged area.

Remove the nails in the corner cap. First you nail up the new piece driving nails through the slots in the nail hem then you connect the buttlocks with the zip tool. Remove the nails by using a pry bar. Use a zip tool image 1 to unlock the siding from the surrounding pieces image 2.

Cut out damaged section of vinyl siding. Remove the nails on. Installing a replacement piece of vinyl siding is the reverse of removing the damaged panel. Be careful because older siding can become brittle.

Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment. Use the zip tool to release the buttlock at the top and bottom of the piece you want to remove. It ll better match the house. How to repair and replace siding step 1.

Hgtv expert henry harrison shows how you can reattach it using a vinyl siding removal tool also known as a zip tool. 15 minute vinyl siding repair with a zip tool starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel. Score down the damaged lap siding with a utility knife. First remove the corner piece then slide the zip tool under the siding and loosen it up.

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes.