Use a pry bar to remove the damaged siding.
Replace one piece of wood siding.
Nail the replacement siding board into place initially by driving nails through the existing holes in the top board.
Take the replacement board fit it in place image 2 and nail it in with a hammer using galvanized nails.
How to remove and replace wood siding.
Slide the replacement siding board upward underneath its top neighbor.
Fill in the nail holes.
Starting at one end of the damaged piece push the end of the zip siding.
Hold any pieces above the.
Use a small hacksaw with a sharp blade.
Nail the replacement siding board in place.
The nailheads on existing siding will indicate stud positions.
Place the replacement piece of siding in the proper location pushing up until the lower lip locks with the piece below.
Slip a flat bar behind the vinyl siding and lever out the nails.
Cut and prime.
How to change a piece of broken wood siding 1.
Nail straight down on the replacement board in order to hit studs.
Carefully slide the flat pry bar behind the damaged siding in order to pry out the nails.
Cut through the nails that are holding the old siding in place.
Use a square to mark the cutting lines centered on a stud.
Remove any nails from the top piece of good siding.
An oscillating tool with a.
Cut existing siding nails.
To remove and replace damaged siding.
Slip a pry bar under the bottom edge of the broken board near one of the nails holding the board in place.
Make sure that the board is flat against the side of the house.
Cut the nails at the bottom of the row above the boards you re replacing.
Using the same process in step one unzip the piece of siding above the damaged piece and hold it out of the way.
Be sure to nail into the existing holes on the adjacent siding.
Project step by step 3 15 minute vinyl siding repair with a zip tool.
When crosscutting the existing siding be sure to stagger the end joints so they aren t aligned.
Cut the fiber cement siding to length wear approved dust protection.
Pull up on the.