Replacing A Damaged Piece Of Vinyl Siding

Install the replacement piece over the existing siding and attach with roofing nails.

Replacing a damaged piece of vinyl siding.

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. 15 minute vinyl siding repair with a zip tool. Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip. When replacing siding try to purchase a piece from the same manufacturer in the same color.

With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall. Subscribe to this old house. Patching and replacing panels. But if you need to replace a vinyl panel or part of a panel check your garage or basement to see whether the installer left extra pieces for repairs.

Pull the nails holding the damaged siding and remove the damaged piece. This gives you about 1 of overlap on both ends. You must also cut back the nail hem about 2 on each side of the replacement panel so it fits into the space of the removed section. Use tin snips to cut out the damaged area image 1.

Then lock the siding back into place. The vinyl siding zip tool will save you loads of time. Hold the loose undamaged piece of vinyl up and out of the way with one hand. Run a bead of adhesive caulk around the back of the patch and set the patch in place top image.

The patch should be larger than the piece you removed. The total amount to replace a damaged section of vinyl siding averages 80 90. To repair a single piece of damaged vinyl siding usually takes a contractor one hour to remove the damaged piece lay any underlayment 9 and replace it with a new piece. Cut out the damaged piece of siding leaving a space 2 inches shorter than the replacement piece.

This piece walks you through two common projects. Cut the replacement piece of vinyl siding about 3 longer than the section you removed. Push the new piece into the nailing strip of the course below. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.

If a vinyl piece has come apart from its neighbor the solution is often to push it back up until it locks in place. Work your hand into a seam between pieces then release the siding from the nailing strip.