Remove switch bezel and disconnect power window memory switch.
Removing door panel 02 town and countrry.
Here is the procedure to remove the drivers front door panel removal.
The right side power sliding door will not close completely.
Disconnect all electrical connectors leading to the latch assembly.
Remove the weather shield if necessary.
Note do not use the front door trim panel to remove the trim clips from the door inner panel.
Remove the two screws on the front and rear side of the front door trim panel.
To remove the oem door speaker you ll need a torx t 25 screwdriver.
Remove screws attaching trim panel to door from below map pocket.
Partially close the door and pull the latch assembly out of the side door inner panel.
I have a 2006 chrysler town country van with power sliding doors.
The tools needed to remove the door panel include a small flathead screwdriver a torx t 20 star bit screwdriver a flathead screwdriver or a plastic trim panel removal tool and needle nose pliers.
The power window motor screws are torx t 30.
Open the side door all the way and remove the door latch retaining bolts.
Any ideas what needs to be.
When closing it stops approx 6 8 inches from the door jamb and must be closed manually.
If equipped remove window crank.
The only tools you ll need are a 12 mm wrench to unhook the battery and then you ll need a phillips screwdriver and either a door panel clip tool or a putty knife.
Want to remove driver side door panel to gain access to power window motor first remove the tweeter speker if equipped this comes off easily by gently prying from behind then remove the small panel behind pull handle you ll find a screw behind it remove that the next part is a little tricky the door grip needs to come off to achieve this place a small flat screwdriver at the top of.
Replace any bent damaged or missing push pins.
2006 chrysler town country van.
Remove the appropriate side door trim panel.
Remove the plug and remove screw attaching door pull cup to inner door panel.